Matek HUBOSD eco H-Type STOSD8 Current Sensor 140A Dual BEC 3-5S Plug and Play
The HUBOSD eco has been engineered to provide the highest possible performance and reliability in a 46*36mm & 4 layers PCB.
It is a multifunctional HUB with PDB, BEC 5V/2A &12V/500mA, Current sensor 140A, STOSD8. It is specially made for the mini FPV Quad.
The BEC 12V is linear regulator, no LC Filter needed. Built-in STOSD8 can support Plug & Play, no complicated settings needed.
Features:
Specifications:
Package Contents:
It is a multifunctional HUB with PDB, BEC 5V/2A &12V/500mA, Current sensor 140A, STOSD8. It is specially made for the mini FPV Quad.
The BEC 12V is linear regulator, no LC Filter needed. Built-in STOSD8 can support Plug & Play, no complicated settings needed.
Features:
- 33x16.5 mm
- 2 gram without headers
- 3-axis MEMS gyro + accelerometer (MPU6050)
- STM32F103CBT6 32-bit Cortex M3 processor
- Direct conntect to Airbot 35x35 GPS /Compass
- Only supports PPM RC Input
- 6 motor outputs for multirotor mode, incl. pads for Battery voltage monitoring
- Additional UART pads for Battery and Buzzer
- Direct conection of spectrum satellite
- Onboard MicroUSB for setup and configuration
- MultiWii-based configuration software for easy setup
- Weight: Approx 5g (excluded cable set)
Specifications:
- input voltage range (3S-5S operation): 8 - 21VDC
- PDB: 4x30A (Max.4x35A)
- Regulated 5V and 12V outputs
- Current Sensor 140A
- Built-in STOSD8
- Continuous current: 30A per output
- Peak current (10 seconds/minute): 35A per output
- Continuous current: 2 Amps (Max.2.5A 10s/minute)
- Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)
- Short-circuit tolerant (5 seconds/minute)
Package Contents:
- 1x Matek HUBOSD PDB