APM2.6 PixHawk Power Module with XT60 Connectors 10S 45V 90A
APM2.6 PixHawk Power Module with XT60 Connectors 10S 45V 90A
Product Type: Power Regulator
Brand: RTS
Compatibility: APM/Ardupilot
Compatibility: PixHawk
Sensor or Module: Current Sensor
Brand: RTS
Compatibility: APM/Ardupilot
Compatibility: PixHawk
Sensor or Module: Current Sensor
Included 6-pin cable that directly matches the PixHawk connector. The on-board switching regulator outputs 5.3V at a maximum of 2.25A, and can be used up to 45Volts (10S LiPo) and at a maximum of 90 amps. The Power Module is ready to use with XT60 connectors pre-fitted, and shrink-wrapped for protection.
Note: The Power Module is rated at 2.25 Amps to power the HKPilot, receiver, and peripherals (GPS and Telemetry radio) ONLY. To power servos use an ESC with an adequate BEC or a standalone BEC plugged into the output bus and remove jumper 1 to isolate the two power lines.
Specifications:
Package Contents:
Note: The Power Module is rated at 2.25 Amps to power the HKPilot, receiver, and peripherals (GPS and Telemetry radio) ONLY. To power servos use an ESC with an adequate BEC or a standalone BEC plugged into the output bus and remove jumper 1 to isolate the two power lines.
Specifications:
- Max input voltage: 45V
- Max current sensing:90A
- Switching regulator outputs: 5.3V at 2.25A max
- Connector: 6-pos Molex cable plugs directly to HKPilot/APM/PX4 'PM' connector
- Voltage and current measurement configured for: 5V ADC
Package Contents:
- DF13 6 Position Connector 150mm long
- HKPilot Power Module with XT60 Connectors